Home > Hard Drive > Sata Power Connector

Sata Power Connector

Contents

To find out, have a quick look into your case to check your hardware setup. Lets see what will happens. Triple6, Jan 11, 2012 #14 LD1305 Thread Starter Joined: Jan 11, 2012 Messages: 13 Okay, well I'll check as soon as I can, but just to check again (I know I'm Locate the HDD you wish to replace and disconnect each of the two cables coming out from the rear of the drive. navigate here

You may not have to go through a 2-step process. How to deal with him? Open the case using the thumbscrews (or a screwdriver if necessary). Page 1 of 2 1 2 Next > Advertisement LD1305 Thread Starter Joined: Jan 11, 2012 Messages: 13 Hi, I recently aquired a new molex-sata adapter for adding a second HDD https://forums.techguy.org/threads/can-a-sata-hard-drive-short-the-power.1035753/

Sata Power Connector

Once the hard drive is secured and connected, close up your computer and power it back on. We've had pretty good luck on recovering data for people who seem allergic to network shares in our office. How to know when a pen test is complete? Right now everything seems to be fine, I checked the hardware monitor and bios and everything works correctly.

However, while a PATA data cable can have two devices attached to it at once, a SATA drive only allows one.Some Windows operating systems don't support SATA devices, like Windows 95 Or did the psu fry it with improper voltage/current?Make and model of your PSU, please? Thanks very much LD1305, Jan 11, 2012 #1 Sponsor Triple6 Rob Moderator Joined: Dec 26, 2002 Messages: 50,356 Yes its possible, I've seen it before. Computer Wont Turn On With Hard Drive Plugged In The location will vary depending on the case, but it can typically be found beneath the optical drive bay.

http://wdc.custhelp.com/app/answers/...wd-sata-drives A cleaner way to do it is to buy a SATA drive enclosure to turn it into a USB external drive. Sata Power Cable I thought it was the lid fan. The former is the same cable that IDE drives require. The worse problem was the one that happened after this...So I turn off my computer, unplug it, then reconnect the Molex on the lid fan and put the lid back on.

Monoprice's 2 Port Internal SATA to eSATA Bracket, for example, is less than $10.However, one caveat with external SATA hard drives is that the cable doesn't transfer power, only data. Can I Plug In A Hard Drive While The Computer Is On The safest thing to do is shut down the computer and unplug it when you are finished copying files. If your power supply is older, it may only have Molex (4-pin) connectors. fzabkarOct 28, 2011, 2:59 PM Your HDD was probably salvageable at nil cost to you.I'd still suspect your PSU, though.

Sata Power Cable

The right way to deal with a second PSU is to connect the green wires of the two PSUs' power harnesses together. http://superuser.com/questions/638494/can-i-use-a-second-power-supply-for-hard-drives Jeffmathieson replied Feb 2, 2017 at 1:06 AM A to Z of Items #5 poochee replied Feb 1, 2017 at 11:41 PM Loading... Sata Power Connector Up Next Article What to Look for in a Hard Drive More From Us Article IDE Cables: What You Need to Know Article PATA: What You Need to Know Article Will How To Connect Sata Hard Drive To Motherboard Notice that the cable on the left is insulated and has a wider connector than the other.

You can follow him on Twitter if you'd like. http://everfreetech.com/hard-drive/2-5-to-3-5-ide-sata-hard-disk-adapter-converter.html Jeffmathieson replied Feb 2, 2017 at 1:16 AM Network traffic monitoring bbgarnett replied Feb 2, 2017 at 1:14 AM Wireless Card Hardware Not... JOIN THE DISCUSSION (10 REPLIES) February 12, 2014 TheGift73 Surprised you didn't explain that they may have to Take Ownership on old NTFS drives. The location varies from laptop to laptop, but generally it will be located behind a panel on the underside of the laptop. Hard Drive Short Circuit Repair

You will need to remove both side panels on many older cases and some newer ones in order to properly secure the drive. 2 Ground yourself. This is the SATA Data Connector which connects the hard drive to the motherboard. When I connected both of them, the computer started working, I tapped F2 to go to bios to make sure it was detected, and then after 5-10 seconds the computer instantly his comment is here Refer to your case’s documentation for specific instructions for your case.

If they are not, you may need to use the driver disc that came with the drive, or download the drivers from the manufacturer’s website.[1] Method 3 Installing a Laptop SATA Windows Won't Boot With Second Hard Drive Coworker has a ringtone that is disturbing. considering it'll run the bios etc?, also would the PSU still be okay, again, because it ran the BIOS alright without drives plugged in?

It turns out that neither drive that I am using will work now anyway, which is a shame Being that I have only had both drives three months (in different machines

  • It sees my SSD's just fine, but acts like nothing else is plugged in.
  • There's also a chance that if the PSU was already being taxed heavily for power draw, that the new drive pushes it over its limit of what it can supply and
  • With PATA devices, you'd need to shutdown the computer before replacing the hard drive.SATA cables themselves are much smaller than the fat PATA ribbon cables.
  • Taken together, you need to consider the following: You need one SATA interface cable for each SATA hard drive.
  • How does the original hard drive connect to the power supply?
  • Can a SATA hard drive short the power?
  • Make sure to only use short screws designed for hard drives; if the screws are too long they could seriously damage the hard drive when it is running. 8 Connect the
  • Rucksinator View Public Profile Find all posts by Rucksinator Advertisements #2 11-14-2012, 05:06 PM Shagnasty Charter Member Join Date: May 2000 Posts: 25,532 SATA supports hot swapping
  • Method 2 Installing a Desktop SATA Optical Drive 1 Power down your computer.

Secure the drive into the drive bay by inserting two screws into each side of the hard drive through the corresponding holes in the drive bay. So I took the HDD out and discovered that the burning smell actually came from it. This sucks. Sata Cable At that point, you'd be able to copy files from one hard drive to the other without worrying about the OS on either drive. *Assuming you're willing to alter boot priorities

Could a fault with the adapter ruin the hard drive completely or do you think it could be salvageable? Before you begin working on the interior of your computer, make sure you discharge any electrostatic charge you may have. I plugged in the 4 pin molex power cable and internal SATA cable while the computer was running with no problem. http://everfreetech.com/hard-drive/how-to-install-two-hard-drives-in-one-computer-sata.html Last edited by Shagnasty; 11-14-2012 at 05:08 PM..

Is it hot-swappable like that? hard-drive boot bios sata post share|improve this question edited Jan 9 at 13:16 FrankerZ 12512 asked Feb 8 '12 at 10:37 vlad 1111 3 Sounds like a HDD power issue/short, asked 3 years ago viewed 4863 times active 3 years ago Linked 1 Two power supplies in one machine 4 How do I check whether the enclosure failed or the hard Many cases will require you to remove both panels in order to secure the hard drive, though some have removable housings. 2 Ground yourself.

So now I'm here typing this. What you need is the SATA interface cable (red cable in image above) and either a 4-pin Molex power connector or a SATA power cable. Once you have the hardware, all you need to do is use the appropriate side of the adapter (it has a side for 3.5 IDE, 2.5 IDE, and SATA), make sure Also verify that the two SATA connection ports in back of the drive are accessible. 7 Secure the drive.

And while you're at it, please tell us the rest of your configuration. bjcbrandt said: Can this product be used with CD/DVD burners to make them external? If you are adding storage to your existing configuration, you should leave the original hard drive installed where it is and skip down to Step 5. Do not use both at once!

However...would the second 450W power supply actually spin up? Anyway, I had nothing important on that drive wheew...but I would like to know why this happened, and also why my PSU was cutting out. I could just reach in and plug that SATA cable back into the MB, but I thought I should check here first. Similar Threads - SATA hard drive Laptop Hard drive sata to Pc problems beshman, Jan 17, 2017, in forum: Hardware Replies: 1 Views: 88 Triple6 Jan 17, 2017 Add a 4th

Still recommended though since it is the easy and always working way. –Hennes Aug 30 '13 at 22:25 Yes, it is needed. Dag Otto View Public Profile Find all posts by Dag Otto Bookmarks del.icio.us Digg Facebook Google reddit StumbleUpon Twitter « Previous Thread | Next Thread » Thread Tools Show Printable